- Tighter - Better insulated - Clean - Engineered to efficiently handle total higher airflow - Engineered and balanced to deliver air to rooms in proper proportions - Engineered to solve internal room to room pressure imbalances - Engineered to be quitter - Performance tested It is essential that evaluate the duct system, and if necessary make improvements, in order to receive the anticipated energy savings.

updating old auto air conditioning-39

If you’re about to go to bed and want to avoid nightmares, you might want to put off reading this until morning. While Black Death is not the same as the deadly plague during the 14th century, a car system experiencing Black Death will be infected like the plague.

Black Death starts out inside the compressor after refrigerant breaks down.

If you are an automotive air conditioner technician, this manual provides you with the background necessary to make an informed decision about retrofitting your customer's vehicles.

If you are a do-it-yourselfer, this manual will enable you to plan the retrofit project on your own car to match your capabilities.

Before you know it, all cold air, and airflow for that matter, will be long gone. The best protection from Black Death is an A/C Performance Check. We feel your pain and discomfort caused by weak airflow.

The sweat alone is enough to drive any of us crazy. If you notice reduced airflow early on –rather than later– take the right step and have it looked at before other fatal A/C system damage can occur.) that may display the status of many vehicle systems. There are several reasons an A/C system can lose its cool.Bring your ride to us as soon as you start noticing this symptom, it could mean the difference between needing a small repair, or worse, a large one. Rubber seals and hoses can also lose their elasticity over time and breakdown allowing Freon to escape and moisture to enter your vehicle’s A/C system.In order to determine the performance of your current duct system, have Jon Wayne perform a full diagnostic check up.Measurement test will be conducted for air leakage, pressure, airflow and speed.Your ducts were more than likely designed and installed by the lowest paid worker for the lowest bidding HVAC contractor the builder could find.